Choose a location for your Sharp atomic clock that is at least six feet from electronic devices such as televisions, stereos or computers. These and other electronic devices might interfere with your clock's ability to receive the radio-controlled time signal. 2. Insert a battery or batteries into the battery compartment of the Sharp atomic clock.

Customer: I have a Sharp Atomic Clock Model SPC 364. I am in the Eastern Time Zone, but the clock shows the time in the Pacfic Tiome Zone.

4) Place the clock near a westerly window overnight and then the clock should reset overnight and read the correct time. **If you had previously pushed the manual mode flap (switch), take a pen or paperclip and make sure it is pulled out in the off position.

Customer: I have a Sharp Atomic Clock SPC936. The outside temp sensor is not displaying the temp on the clock. The outside temp sensor is not displaying the temp on the clock. I have tried all the troubleshooting tips I could find but none work.

i have a sharp "atomic clock" that works just fine except it is stuck in the pacific time zone and the "central time Craig 33 years troubleshooting electronic and electrical control systems for all types of equipment.

All you need to do is wait until the clock automatically connects with the broadcast from the atomic clock in Colorado and adjusts the time itself (the clock automatically connects at 2:00 AM). If you want to set it immediately, however, you can press the RECEIVE button to connect.

Customer: I seek instructions for configuring the Sharp SPC323 "Atomic" clock. It appears to use a different module than those clocks for which I can find information. Technician's Assistant: How long have you had your SPC323? Customer: I've had it 10-15 years. But, I purchased it on eBay, so that it could easily be 5-10 years older than that ...

Craig : Once the battery is installed the clock will begin to seek the radio signal to update the time. This typically takes between 5-8 minutes in good conditions.

How can I reset my sharp Atomic Clock to reflect the new time (One Hour Back) for the new Daylight Savings Time which Lurch Aftermarket & Factory Mobile Electronics.

The AM signal delivers the exact time to a Sharp atomic clock from up to 2,000 miles away. Sharp suggests that you manually set the time zone and time before attempting an update through the radio control feature. Instructions Manual Set. 1. Press the "Mode" button on the Sharp atomic clock to enter the alarm time mode, labeled "AL."